Select Page

ViLX-ACP-66

The ViLX-ACP-66 weatherproof ancillary cancel button is fully compatible with the Lexicomm EVC range of equipment and the standalone Assist Call range.

  • IP66 Weatherproof enclosure
  • Ideal for showers/wet areas
  • Stainless Fascia
  • Polycarbonate Back box
  • Flush or surface mounting
  • BS 8300-2:2018 “Acknowledge” feature

The ViLX-ACP-66 is used to cancel the alarm when additional cancel buttons are required. It is suitable for showers and other wet areas where a standard cancel button may be unsuitable.

The cancel button is finished in brushed stainless steel without visual indication, so it should be used in conjunction with another cancel button or cancel plate which has visual indication.

 

Operation

The button is a momentary sprung switch which cancels the alarm when pressed.

Up to 2 x ancillary cancel buttons can be used in the circuit, for further advice please refer to Vox Ignis technical dept for guidance.

 

Mounting Information

It should be mounted at between 800mm to 1000mm with a lower call button mounted at 100mm from the floor.

There are 5 x 20mm cable entries provided, at top, bottom and side entry, cable entry for the rear via cut-out is also provided. See drawings overleaf for full details.

 

Wiring Information

For simplicity, all wiring is a standard two core cable, the wiring order of the devices is not fixed and therefore can be wired in any order to give total flexibility.

Physical

Height100mm
Width100mm
Depth60mm
Weight250 g
MaterialStainless Steel/ Acrylic
FinishBrushed

Part Numbers

Ancillary Cancel PlateViLX-ACP-66

Recommended Cables

TypePVC or Fire Rated*
Cores2 core 1mm CSA
Distance500m from compatible panel/ controller

Standards Compliance

EMCEN 55035:2017+A11:2020
LVDEN IEC62368-1:2020 +A11:2020
Product FamilyBS 5839-9:2021, BS 8300-2:2018
*If connected to a Refuge Point